Hyundai Accent Manuals

Hyundai Accent: Inspection - Thermostat. Repair procedures - Cooling System - Engine Mechanical SystemHyundai Accent: Inspection

Hyundai Accent RB (2010-2018) Service Manual / Engine Mechanical System / Cooling System / Thermostat. Repair procedures / Inspection

1.
Immerse the thermostat in water and gradually heat the water.
2.
Check the valve opening temperature.
Valve opening temperature : 82±1.5°C (179.6±2.7°F)
Full opening temperature : 95°C (203°F)
If the valve opening temperature is not as specified, replace the thermostat.
3.
Check the valve lift.
Valve lift : 8mm(0.3in) or more at 95°C (203°F)
If the valve lift is not as specified, replace the thermostat.

Removal
Disassembly of the thermostat would have an adverse effect, causing a lowering of cooling efficiency. 1. ...

Installation
1. Place the thermostat in the block. Install the thermostat (B) with the jiggle valve upward. 2. Install the water inlet fitting ( ...

See also:

Front Impact Sensor (FIS). Description and Operation
Description The front impact sensor (FIS) is installed in the front side member. They are remote sensors that detect acceleration due to a collision at its mounting location. The primary pur ...

Adjustment
Operate the horn, and adjust the tone to a suitable level by turning the adjusting screw. After adjustment, apply a small amo ...

Anti-lock brake system (ABS)
WARNING ABS (or ESC) will not prevent accidents due to improper or dangerous driving maneuvers. Even though vehicle control is improved during emergency braking, always maintain a safe distance ...

Hyundai Accent Manuals

© 2011-2025 Copyright www.hamanual.com