Hyundai Accent Manuals

Hyundai Accent: Removal - Injector. Repair procedures - Engine Control System - Engine Control/Fuel SystemHyundai Accent: Removal

Hyundai Accent RB (2010-2018) Service Manual / Engine Control/Fuel System / Engine Control System / Injector. Repair procedures / Removal

In case of removing the high pressure fuel pump, high pressure fuel pipe, delivery pipe, and injector, there may be injury caused by leakage of the high pressure fuel. So don’t do any repair work right after engine stops.
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Release the residual pressure in fuel line (Refer to “Release Residual Pressure in Fuel Line” in this group).
When removing the fuel pump relay, a Diagnostic Trouble Code (DTC) may occur. Delete the code with the GDS after completion of “Release Residual Pressure in Fuel Line” work.
3.
Remove the delivery pipe & injector assembly (Refer to "Delivery Pipe" in this group).
4.
Remove the connector (A) and the fixing clip (B), and then separate the injector from the delivery pipe.

Inspection
1. Turn the ignition switch OFF. 2. Disconnect the injector connector. 3. Measure resistance between the inject ...

Installation
1. Combustion seal 2. Rubber washer 3. Support disc 4. O-ring ...

See also:

Inspection
1. Check the audio remote control switch (A) for resistance between terminals in each switch position. Switch C ...

Installation
• Install the component with the specified torques. • ...

Care of disc
If the temperature inside the car is too high, open the car windows for ventilation before using your car audio. It is illegal to copy and use MP3/WMA files without permission. Use CDs that ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com