1. |
Remove the battery and the battery tray.
(Refer to "Charging system" in EE group.)
|
2. |
Remove the under cover (A).
|
3. |
Replace new gasket and the plug after draining the automatic transaxle
fluid by removing the drain plug. (Refer to "Hydraulic system (Fluid)"
in this group)
|
4. |
Remove the valve body cover (B).
|
5. |
Remove thd air breather hose (A).
|
6. |
Remove the plate and the detent spring (A) after removing the
bolt.
|
7. |
Remove the bolt (3ea) after disconnecting the solenoid valve (B)
connector and the oil temperature sensor connector (A).
|
8. |
Remove the valve body assembly (A).
|
Removal
PODS-F ECU
1.
Disconnect the battery negative cable, and wait for at least three
minutes before beginning work.
2.
Remove the front pa ...
To increase cruise control set speed
Follow either of these procedures:
Push the RES+ switch and hold it. Your vehicle will accelerate. Release
the switch at the speed you want.
Push the RES+ switch and release it immediately. ...
Tightening Torque Table Of Standard Parts
Bolt nominal
diameter (mm)
Pitch (mm)
Torque Nm (kg.cm, lb.ft)
Head Mark 4
Head Mark 7
...