Hyundai Accent Manuals

Hyundai Accent: Replacement - Transaxle Control Module (TCM). Repair procedures - Automatic Transaxle Control System - Automatic Transaxle SystemHyundai Accent: Replacement

Hyundai Accent RB (2010-2018) Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Transaxle Control Module (TCM). Repair procedures / Replacement

1.
Turn ignition switch OFF.
2.
Disconnect the negative (-) battery cable.
3.
Disconnect the TCM connector (A).
4.
Remove the TCM after removing the bolt and nut.
TCM installation bolt/nut:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)


Inspection
TCM Problem Inspection Procedure 1. TEST TCM GROUND CIRCUIT: Measure resistance between TCM and chassis ground using the backside of TCM harness connector as TCM side ...

Installation
1. Installation is reverse of removal. In the case of the vehicle equipped wi ...

See also:

Wheel nut tightening torque
Steel wheel & aluminum alloy wheel: 65~79 lb·ft (9~11 kg·m) If you have a tire gauge, remove the valve cap and check the air pressure. If the pressure is lower than recommended, drive slowly ...

To resume cruising speed at more than approximately 25 mph (40 km/h)
If any method other than the cruise ON/OFF switch was used to cancel cruising speed and the system is still activated, the most recent set speed will automatically resume when the RES+ switch is ...

Fender. Repair procedures
Replacement • When removing and installing the fender, an assistant is necessary. ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com