Replacement
|
1. |
Remove the front bumper cover.
(Refer to the BD group – “Front bumper”)
|
2. |
Loosen the mud guard mounting screws.
|
3. |
After loosening the mounting screws, then remove the front bumper
side mounting bracket (A).
|
4. |
Using a screwdriver or remover, remove the fender side cover (B).
|
5. |
After loosening the mounting bolts and nut, then remove the fender
(A).
|
6. |
Installation is the reverse of removal.
|
Line Pressure Control Solenoid Valve. Specifications
Specifications
Direct control VFS[LINE Pressure]
▷ Control type : Normal high type
Control Pressure kpa
(kgf/cm², psi)
500.14 ~ 9.81
(5.4 ~ 0.1, 7.6 ...
Using the Tire Mobility Kit
1. Detach the speed restriction label (0) from the sealant bottle (1), and place
it in a highly visible place inside the vehicle such as on the steering wheel to
remind the driver not to drive too ...
Immobilizer Control Unit. Repair
procedures
Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the crash pad lower panel.
(Refer to the BD group - "Crash ...