Hyundai Accent Manuals

Hyundai Accent: Installation - SS-A Solenoid Valve(ON/OFF). Repair procedures - Automatic Transaxle Control System - Automatic Transaxle SystemHyundai Accent: Installation

1.
Installation is the reverse of removal.
•
The gasket of the valve body cover gasket (A) use new one.
•
Adding automatic transaxle fluid.
(Refer to "Hydraulic system (Fluid)" in this group)

•
Perform TCM learning after replacing the automatic transaxle to prevent slow automatic transaxle response, jerky acceleration and jerky startup.
(Refer to "Automatic transaxle control system (Repair procedures)" in this group)

Removal
Replacing an on/off solenoid valve (SS-A, SS-B) does not require additional hydraulic pressure adjustment; however, the hydraul ...

SS-B Solenoid Valve(ON/OFF). Description and Operation
Description SS-B solenoid valve is attached to the valve body and is an on/off solenoid valve that is used to change gears. SS-B Solenoid valve(ON/OFF) is installed at valve body. ...

See also:

Sunroof Switch. Repair procedures
Inspection 1. Disconnect the negative (-) battery terminal. 2. Open the sunglass case cover from the overhead console then remove the 2 sc ...

Troubleshooting
Troubleshooting Starting System Symptom Suspect area Remedy Engine will not crank Battery charge low Charge or replace batt ...

Rear Glass Defogger Switch. Repair procedures
Inspection 1. Disconnect the negative (-) battery terminal. 2. Using a screwdriver or remover, remove the center fascia garnish (A). ...

Hyundai Accent Manuals


© 2011-2025 Copyright www.hamanual.com