Hyundai Accent: Reassembly
| 1. |
Wrap tape around the driveshaft spline(TJ) to prevent damage to
the boots.
|
| 2. |
Apply grease to the joint boot on the side of the wheel and install
the boot.
|
| 3. |
Install the clamp.
|
| 4. |
Assemble the transaxle side joint boot and bands.
|
| 5. |
Using the alignment marks (D) made during disassembly as a guide,
install the spider assembly (A) and snap ring (B) on the driveshaft
splines (C).
|
| 6. |
Add specified grease to the joint boot as much as it was wiped
away at inspection.
|
| 7. |
Install the both boot band.
|
| 8. |
To control the air in the TJ boot, keep the specified distance
between the boot bands when they are tightened.
|
|||||||||||||
| 9. |
Using the SST (09495-3K000), secure the TJ boot band.
|
Disassembly
•
Do not disassemble the BJ assembly.
•
Speci ...
See also:
Removal
1.
Disconnect the battery (-) terminal.
2.
Remove the audio unit.
(Refer to the BE group - "Audio")
3.
...
Vehicle identification number (VIN)
The vehicle identification number (VIN) is the number used in registering your
car and in all legal matters pertaining to its ownership, etc.
The number is punched on the floor under the front pa ...
Front Body E ( 5Door )
Hood hinge mounting hole (Ø10)
Fender apron upper member tooling
hole (Ø6.6)
Cowl under ...
Hyundai Accent Manuals
© 2011-2026 Copyright www.hamanual.com