Hyundai Accent: Removal
| 1. |
Remove the ignition key from the vehicle.
|
| 2. |
Disconnect the battery negative cable and wait for at least three
minutes before beginning work.
|
| 3. |
Remove the floor console.
(Refer to the Body group - "Console")
|
| 4. |
Remove the rear heating joint duct (A).
|
| 5. |
Pull up the lock, of the SRSCM connector, the disconnect the connector
(A and B).
|
| 6. |
Remove the SRSCM mounting nuts (3EA) from the SRSCM, then remove
the SRSCM.
|
Installation
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least three
minutes before beginning ...
See also:
Wheel. Repair procedures
Hub Nut Tightening Sequence
Tighten the hub nuts as follows.
Tightening torque :
88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)
...
Installation
1.
Install the bulb.
2.
Connect the connector and install the trunk trim.
...
Removal
Door Mirror Turn Signal Lamp
1.
Remove the mirror (A) from the mirror holder. Be careful not to
damage to the clip.
2.
Remove ...
Hyundai Accent Manuals
В© 2011-2026 Copyright www.hamanual.com