Hyundai Accent Manuals

Hyundai Accent: Adjustment - Rear Door. Repair procedures - Exterior - Body (Interior and Exterior)Hyundai Accent: Adjustment

Glass Adjustment
Check the glass run channel for damage or deterioration, and replace them necessary.
1.
Remove the following parts.
A.
Door trim
B.
Door seal
2.
Carefully move the glass (A) until you can see the glass mounting screws, then loosen them.

3.
Check that the glass moves smoothly.
4.
Raise the glass fully, and check for gaps.
Check that the glass contacts the glass run channel evenly.
Door Striker Adjustment
Make sure the door latches securely without slamming it. If necessary adjust the striker (A): The striker nuts are fixed. The striker can be fine adjusted up or down, and in or out.
1.
Loosen the screws (B) just enough for the striker to move.

Tightening torque :
(B): 8.8 ~ 13.7 N.m (0.9 ~ 1.4 kgf.m, 6.5 ~ 10.1 lb-ft)

2.
Tap on the striker with a plastic hammer to adjust the striker. The striker will not move much, but will give some adjustment.
3.
Hold the outer handle out, and push the door against the body to be sure the striker allows a flush fit. If the door latches properly, tighten the screws and recheck.
Door Position Adjustment
After installing the door, check for a flush fit with the Body, then check for equal gaps between the front, Rear, and bottom, door edges and the body. Checkthat the door and body edges are parallel. before Adjusting, replace the mounting bolts.
1.
Check that the door and body edges are parallel.

2.
Place the vehicle on a firm, level surface when adjusting the doors.
3.
Adjust at the hinges (A) :
A.
Loosen the door mounting bolts slightly, and move the door in or out until it aligns flush with the body.
B.
Loosen the hinge mounting bolts slightly, and move the door backward or forward, up or down as necessary to equalize the gaps.
C.
Place a shop towel on the jack to prevent damage to the door when adjusting the door.

Tightening torque :
(B) : 21.6 ~ 26.5 N.m (2.2 ~ 2.7 kgf.m, 15.9 ~ 19.5 lb-ft)
(C) : 33.3 ~ 41.2 N.m (3.4 ~ 4.2 kgf.m, 24.6 ~ 30.4 lb-ft)

4.
Grease the pivot portions of the hinges indicated.
5.
Check for water leaks.

Replacement
Rear Door Trim Replacement • Take care not to scratch the door trim and other parts. ...

Body Side Moldings. Repair procedures
Replacement Trunk Lid Garnish Replacement [Sedan] • When prying with a flat-tip ...

See also:

Rocking the vehicle
If it is necessary to rock the vehicle to free it from snow, sand, or mud, first turn the steering wheel right and left to clear the area around your front wheels. Then, shift back and forth betwe ...

Inhibitor Switch. Description and Operation
Description Inhibitor Switch monitors the lever's position(PRND) and is used to control gear setting signals. ...

PODS-F Zeroing procedure
You should perform PODS-F Re-zero procedure after service or replacement about all part of the passenger seat. (Not included full seat assembly) 1. Ignition “OFF” ...

Hyundai Accent Manuals


© 2011-2025 Copyright www.hamanual.com