1. |
Turn the ignition switch OFF and disconnect the battery
negative (-) cable.
|
2. |
Lift the vehicle.
|
3. |
Remove the fuel tank. (Refer to "Fuel Tank" in this
group.)
|
4. |
Disconnect the vapor tube quick-connector (A) and
the vapor hose (B).
|
5. |
Remove the canister assembly after removing installation
bolts (C).
|
Inspection
1.
Disconnect the ignition switch connector (B) and key switch connector
(A) from under the steering column.
2.
Check for continui ...
Tightening Torques
Engine Control System
Item
kgf.m
N.m
lb-ft
ECM installation bolt
1.0 ~ 1.2
9.8 ~ 11.8
7.2 ~ 8.7
...
Rear combination light bulb replacement (4 Door)
(1) Stop and tail light
(2) Rear turn signal light
(3) Back-up light
(4) Side marker
1. Open the trunk lid.
2. Remove the service cover by pulling out the service cover.
3. Remove the sock ...