Hyundai Accent: Cleaning
| 1. |
Do not immerse parts in cleaning solvent.
Immersing the yoke assembly and/or armature will
damage the insulation wipe these parts with a cloth only.
|
| 2. |
Do not immerse the drive unit in cleaning solvent.
The overrun clutch is pre-lubricated at the factory
and sol-vent will wash lubrication from the clutch.
|
| 3. |
The drive unit may be cleaned with a brush moistened
with cleaning solvent and wiped dry with a cloth.
|
Inspection
Armature
1.
Remove the starter.
2.
Disassemble the starter as shown at the beginning
of this procedure.
3 ...
Starter Relay. Repair procedures
Inspection
1.
Remove the fuse box cover.
2.
Remove the starter relay(A).
3.
Using an ohmmeter, check t ...
See also:
Output Speed Sensor. Description and Operation
Description
The output speed sensor (A) is a vital unit that measures the rate of
rotation of the transaxle's turbine shaft and output shaft, and delivers the
readings to the TCM. The se ...
Removal
1.
Remove the front wheel and tire.
Tightening torque:
88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)
...
Manual transaxle operation
The shift lever can
be moved into any of the forward gears without pressing the button (1).
You should press the
button (1) when moving the shift lever into reverse.
The manual transaxle has 6 ...
Hyundai Accent Manuals
В© 2011-2026 Copyright www.hamanual.com