Hyundai Accent: Parking Brake Adjustment
|
| 1. |
Remove the floor console to reach the adjusting nut.
|
| 2. |
Loosen the parking brake cable until both operating levers rest
in fully off position.
|
| 3. |
Bring the brake pads in their operating position by pressing the
brake pedal down several times until there is resistance.
|
| 4. |
Tension the parking brake cable by tightening the adjusting nut,
until the operating levers on both calipers lift from the stop, up to
a distance of (A) and (D) between operating lever (B) and stopper (C).
|
| 5. |
Refit the floor console.
|
| 6. |
Parking brake lever in the car must be in fully loosened position.
|
| 7. |
If the handbrake cables where changed, actuate the parking brake
a few times with maximum force to stretch the parking brake cables,
and then control adjusting as above.
|
| 8. |
Check the wheels of their free operation.
|
| 9. |
Test drive.
|
Installation
Rear Drum Brake. Components and Components LocationThermostat. Components and Components
Location
Components
1. Water inlet fitting
2. Thermostat
3. Heater pipe
4. Bypass hose
5. Water temp control assembly
6. Water temperature sensor
7. Gasket
...
Checking the coolant level
WARNING
Removing radiator cap
Never attempt to remove the radiator cap while the engine is operating
or hot. Doing so might lead to cooling system and engine damage and could result
in s ...
Tire and loading information label
The label located on the driver's door sill gives the original tire size, cold
tire pressures recommended for your vehicle, the number of people that can be in
your vehicle and vehicle capac ...