Hyundai Accent: Removal

Hyundai Accent RB (2010-2018) Service Manual / Brake System / ESC(Electronic Stability Control) System / Front Wheel Speed Sensor. Repair procedures / Removal

1.

Remove the front wheel and tire.

Tightening torque:

88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)

2.

Remove the front wheel speed sensor mounting bolt (A).

Tightening torque:

7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.7 ~ 8.8 lb-ft)

3.	Remove the front wheel guard.

4.	Remove the front wheel speed sensor cable mounting bolt.

5.	Disconnect the front wheel speed sensor connector, and then remove the front wheel speed sensor.

6.	Installation is the reverse of removal.

Front Wheel Speed Sensor. Repair procedures

...

Inspection

1. Measure the output voltage between the terminal of the wheel speed sensor and the body ground. ...

See also:

Crankshaft Position Sensor (CKPS). Troubleshooting
Waveform This example shows a typical Crankshaft Position Sensor(CkPS) and Camshaft Position Sensor(CMPS) waveform at idle.The PCM controls the injection and ignition timing by using ...

Removal
Replacing an on/off solenoid valve (SS-A, SS-B) does not require additional hydraulic pressure adjustment; however, the hydraul ...

Power Window Motor. Repair procedures
Inspection Front Power Window Motor Inspection 1. Remove the front door trim panel. (Refer to the BD group - "Front door") 2. ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com